HOME > PICOTEST



 
J2100A
전화문의 : 031-429-5315
메일문의 : sales@analogtest.co.kr


J2100A
Injection Transmer 1Hz - 5MHz





The injection transmer is presently the prevalent method connecting the network analyzer to the circuit being tested, and is primarily used control loop stability measurements. The goal of the transmer is to inject a signal into the control loop being measured, without impacting the permance of the loop. In order to accomplish this to a reasonable degree, The transmer is isolated and theree is capable of floating on a high voltage, such as a Power Factor Corrector (PFC), which is often close to 400VDC. Measuring voltages that exceed the voltage rating of the Bode-100 inputs require attenuation probes.

The usable bandwidth of an injection transmer is generally significantly greater than the 3dB frequency limits. This is because the transmer itself is outside of the measurement, leading many to incorrectly believe that the transmer is a non-critical element.

The bandwidth of the transmer is strongly related to the terminating impedance. The Bode-100, and most network analyzers, provide a 50 Ohm oscillator source impedance. Assuming this impedance the optimal termination resistor is 5 Ohms. This significantly attenuates the injection signal, which is generally beneficial, as a common error in Bode measurements is using a signal which is too large, and theree not a small signal measurement. An added benefit of this low value is that it can generally be left in circuit at all times, simplifying the connection to the network analyzer without appreciably impacting the output voltage of the circuit being tested.


KEY FEATURES:

  • 1Hz supports PFC regulators
  • 5MHz high enough most power supplies and regulators
  • 23 Octave range
  • Low distortion superior precision
  • 5 Ohm termination minimum impact to loop
  • Includes attenuation to assure small signal measurement



 
  Copyright 1999 - 2005 Morning Special
 
  전화번호 : 031-429-5315 / 팩스번호 : 031-624-4315
메일문의 : sales@analogtest.co.kr
  사업자등록번호 : 134-86-53594
대표이사 : 이위형
경기도 의왕시 오전공업길 19 대현테크노월드 1103호
Copyright 2005 (주)케이넌코리아 All Rights Reserved [무단 이메일 수집거부]